Set Up/Initial Use

•For optimal performance, it is recommended that you fully charge the batteries before use.

•For the “Hollywood” you will notice that one of the batteries and the atomizer are pre-assembled along with an empty cartridge. Simply replace the empty cartridge with a full one from your kit by placing it firmly onto the atomizer. To make sure the cartridge is secure, twist it slightly.

•There is no on or off switch. As you press the cartridge to your lips and inhale, the LED light at the tip glows like a real cigarette to let you know its working.  But for the manuel style you will push the button,and draw on the cartomizer. When the desired amount of vapor has built up in your mouth, release the botton and repeat.

Emist “To Go” Travel Case
•Both the case and the battery can be charged using a standard wall outlet, computer with USB port or car charger.

•To charge the case using a wall outlet, simply plug the wall charger into the outlet and connect the USB end into the wall charger adapter. When the LED light at the end of the cord is on, the pack is charging. When the light turns off, your case is fully charged.

•To charge the pack using the enclosed USB charger, unplug the USB cord from the wall charger and connect one end of the cable to the pack and the other to the USB port. When the LED light at the end of the cord is on, the pack is charging. When the light turns off, your pack is fully charged.

•To charge the pack using the car charger, plug the charger into an outlet in your vehicle.  When the LED light at the end of the cord is on, the pack is charging.  When the light turns off, your pack is fully charged.

.Once the pack is charged you can attach your battery to charger in the pack and charge on the go.

Charging Batteries
•To charge the batteries using the wall outlet, place the battery into the E-pack.

•Connect the male end of the USB charging cord to the female end of the cordless wall adapter and plug it into the nearest outlet. A red charger light indicates the battery is charging. The light turns green when the battery has been fully charged and can be removed from the charger.

•To charge the batteries using your computer, simply screw the battery into the USB charger, and then plug the charger into any available USB port. The LED light at the end of the battery will flash and the USB charger light will turn red letting you know it is charging. When the charger light turns green, the battery is fully charged.

•Charging  the travel pack and batteries to capacity takes approximately 1-2 hours.

•Charging the battery takes approximately 45 minutes using the travel -pack.

Replacing Batteries
Each battery will provide approximately two cartridges worth of enjoyment between charges. 

•When the battery is depleted, the LED at the end of the battery will blink 30 times intermittently.

•To replace the empty battery, secure the cartridge in one hand and unscrew the battery from the atomizer.

•Grab the fresh battery from your charger and reattach it to the atomizer. When you’re finished, recharge the empty battery by screwing it back into the receptor in the travel-pack or charging device.

Note: During use, the LED light will flash 10 times to warn you that you are overusing your EMIST and you should take a break. This does not affect performance and does not mean you should recharge.

Replacing Cartridge
On average, each individual cartridge lasts approximately 130 puffs. When the cartridge no longer produces vapor, you’ll know it’s time to change the cartridge.

•To replace the cartridge, hold the battery with one hand and pull off the empty one.

•If using the “Hollywood” check the atomizer for any foam residue and gently brush it aside using your fingers.

•Firmly apply a full cartridge to the atomizer, if using the “Hollywood twist it slightly to make sure it is secure.  If using the other models that are two piece, the atomizer is stored inside the cartridge making it a cartomizer. Just  screw the cartomizer into the battery.